Maintenance notice: These forum archives are read-only, and will be removed shortly. Please visit our forums at their new location, https://www.evilmadscientist.com/forums/.

Alternative method; Electro-Kistka: Dyeing an Egg in Place?

edited June 2014 in General
Hi.

Looking at the EMS blog I found the "Dyeing egg in place" very interesting.
I came up with an alternative method. Disclaimer; I don't have the 'Kistka kit" (yet) - Egg used in illustration is 'plotted' with pens.

1. Place the egg in a small zip-lock bag
( I used a 3x4" or 7.6x10.0 cm approx.)
image


2. Install the egg with the top (open) end over the motor end egg-coupler.
image

3. Pull the bag back and tie off with a string, rubber band or hookup wire.
image

4. Let the Eggbot draw your design.

5. Place the eggbot vertically in a large bowl, motor side up in case of spills.
image

6. Pull the zip-lock bag up over the egg.

7. Fill dye in bag.
image

8.After the dye-period; empty the bag into the bowl by pulling it down over the 'spring-shaft'.
image

9. Rinse & dry off the eggbot / bag with a paper towel.

Repeat steps 3-9 as necessary.

Have fun.
RGDS
Ragnar
Sign In or Register to comment.