Maintenance notice: These forum archives are read-only, and will be removed shortly. Please visit our forums at their new location, https://www.evilmadscientist.com/forums/.

New Diavolino

protheusprotheus
edited June 2012 in Other kit and product support

I Just wanted to say thank you for building such an excellent product.  Also wanted to thank Windell for the help with some questions I had about the board.  As you can see, everything went quite well.  I've got everything assembled, with minor changes (higher intensity blue LED replaces the red one in the kit, and the resistor is correspondingly smaller...)image

It comes on and blinks the LED, as you can see here:
image

Anyway, thanks very much.  I do have one other request for input while I'm here.  As you can see, I haven't yet soldered the battery holder in place.  I'd like for it to be removable, and I'm looking for a good way to do this.  My ideas so far:

Find screw posts that can be soldered into the contact holes.

Solder a set of 90 degree header pins, and attach a corresponding plug to the battery box.  Perhaps difficult to do in a pleasant way, since the contact points are somewhat far apart.  

Cut the wire to the battery box into two halves.  Solder one to the board, using the strain relief holes and so on.  Add a set of matching plugs so that the cable on the board can plug into the cable on the box.

Any other ideas?  Any one of these sound especially better or worse than the others? :)

Chris

Comments

  • Windell OskayWindell Oskay
    I'd suggest attaching the battery box via the USB 6-pin connector, using a 6-pin female header socket strip.   Since you have the USB power jumper installed, you probably don't need to run both power and USB at the same time.
  • protheusprotheus
    Beautiful.  I hadn't thought of that (obviously...), but you're absolutely right.  One source of power at any given time should be enough. :)

    Chris
Sign In or Register to comment.