Maintenance notice: These forum archives are read-only, and will be removed shortly. Please visit our forums at their new location, https://www.evilmadscientist.com/forums/.

Any suggestions?

edited May 2015 in LED Matrix Kits
Hi there, received my Peggy 2 kit yesterday and I've got it all put together, unfortunately it's not all lighting up for me.  Here's a photo of the current condition:  http://i.imgur.com/IZbVqDm.jpg  ; Any suggestions?

Comments

  • For the isolated LED, check the soldering-- most likely issue. Could also be backwards or damaged-- may need to be replaced.

    For the colums out, there appears to be a break or scratch in the vertical wire (trace) on the back side of the pcb. You may be able to see the scratch, but in any case you can repair it by adding an extra wire (e.g., a wire lead from a resistor) across the break or between the two LED leads that are supposed to be connected.
  • edited May 2015
    Thanks for the super fast reply!  I fixed that isolated one last night right after posting this.  Not sure what the deal was but I'm guessing it was a bad LED as it was in there correctly, its replacement is lit up brightly though so that's great.  As for the columns I'll give that a shot, I looked closely and I don't see any obvious trace breaks but I'll try a wire to see what happens.  I'm certain those areas are not getting any power as I attempted what was suggested for another person (put a LEDs leads on the backside to test).  Thanks again!  will report back what I'm able to figure out :)
  • The LEDs are almost never actually "bad" -- in a bag of 1000, I would expect to find zero duds. However, they can be damaged in the installation process, either in the stage of bending out the leads (most likely situation in this case) or during soldering. That's one of the reasons that we include a few extra in the standard LED packs for Peggy.
  • So I added a few jumper lines and now we have life!  The back of the peggy looks like so:  http://i.imgur.com/VZOHtcJ.jpg

    Video of it in action: https://youtube.com/watch?v=BczC7h9_W8E

    Thanks!
  • Perfect. You might want to add a drop of hot glue in the middle of each jumper wire, to prevent the wires from getting eventually broken off.
  • That's a great suggestion.  Much appreciated. :)
Sign In or Register to comment.