Maintenance notice: These forum archives are read-only, and will be removed shortly. Please visit our forums at their new location, https://www.evilmadscientist.com/forums/.

Meggy Jr Question

JohnJohn
edited February 2013 in LED Matrix Kits
I got the Meggy Jr as a Christmas present and recently finished soldering it together. However, columns 1, 2, and 3 do not work. I suspect that the problem is with one of the resistor connections (RB6)  where I used the soldering iron a bit too roughly. Is there any way to fix this?

John   

Comments

  • Windell OskayWindell Oskay
    RB6 does control row 7 of the LED matrix, which (with the sideways matrix) is what we'd normally describe as "the second column."    

    Backing up a bit, "columns" 1,2, and 3 are driven by transistors Q7, Q6, and Q5, from resistors R7, R6, and R5.  If there's a solder blog connecting those three lines together, or a break in the circuit board traces, it could cause the problem that you're seeing.  Look carefully at that area of the board, and see if you can figure out what has actually happened there.  If there's an accidental solder connection, you do need to remove it.
  • JohnJohn
    Thanks Windell, I will try that.
Sign In or Register to comment.