Maintenance notice: These forum archives are read-only, and will be removed shortly. Please visit our forums at their new location,

Ostrich EggBot Plans

edited December 2014 in General
Hi, New here,
 Is there some where I can get full size plans for the Ostrich EggBot?


  • edited December 2014
    Yes, it's an open source project. You can the docs on our documentation wiki, linked from the product page.
  • Can someone give me the measurement of the side and end panels for the Ostrich EggBot?
  • You can get all of the measurements that you need to by opening the original files within Inkscape, and looking at the dimensions there. If you've done some kind of exporting that has lost the dimensions, then you should also double check that the curves came exported cleanly, and that your circles still look like circles, for example.
  • I'm not good with graphics prograns.
Sign In or Register to comment.