Maintenance notice:
These forum archives are read-only, and will be removed shortly.
Please visit our forums at their new location, https://www.evilmadscientist.com/forums/.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- 654 All Categories
- 218 General
- 70 Ask an Evil Mad Scientist
- 6 Blog Projects
- 13 Electronics
- 16 Microcontrollers
- 10 Software Tools
- 0 Fabrication Technologies
- 436 Product Support
- 76 AxiDraw
- 26 WaterColorBot
- 172 Egg-Bot
- 2 AYAB
- 57 Clock Kits
- 23 Larson Scanner and Menorah
- 40 LED Matrix Kits
- 38 Other kit and product support
Servo works great - no movement from stepper motors
I can get connection with the inkscape app and move the servo(pen) up and down but I can not get any movement on the steppers when I use the manual tab or if I try to plot. When I enable the steppers on the manual tab neither stepper seems to energize.
I believe i have the steppers hooked up to the shield properly since I am using the same shield on the Makeangelo drawbot, but I could have then screwed up. Any help would be appreciated.
I have an Arduino Leonardo with a MH Electronics motor shield. I have Ejjduino_Arduino loaded on the Leonardo and I am running inkscape .91 with release 2.4.0 of Eggbot control installed.
Curt
Comments
Sorry, can't help you with that. That's not a hardware configuration that EggBot software supports.