Maintenance notice:
These forum archives are read-only, and will be removed shortly.
Please visit our forums at their new location, https://www.evilmadscientist.com/forums/.
kelvinlee
About
- Username
- kelvinlee
- Joined
- Visits
- 0
- Last Active
- Roles
- Member
Comments
-
Got it.I will populate every rows, thanks.
-
Yes I left several rows. Was that cause the error?
-
Yes.I just bought this panel few weeks ago. I looked the instruction, and checked my panel, jumpers were installed on JP3 & JP4 Is this setting correct?
-
Sorry I am not sure what's "SER" and "P2" mean... But I can say the error line also went wrong during testing with Peggy2 example The top line of green part was brighter than other row
-
Thanks A lot. It works! But I got a new problem. Some bulbs were out of control, I didn't draw it at some frames, but it still glowing not sure which part going wrong..lol Ps. Those error bulbs were on the same row, and also brighter than other…
-
HI I think I had some related problem. I had installed the Peggy2 library (I can run the example on Peggy2 successfully) Then I drew some animation and open it with Arduino, but it shows error like " AnimationFrames" doesn't named a type Don't…
