Maintenance notice:
These forum archives are read-only, and will be removed shortly.
Please visit our forums at their new location, https://www.evilmadscientist.com/forums/.
Roxanne
About
- Username
- Roxanne
- Joined
- Visits
- 0
- Last Active
- Roles
- Member
Comments
-
How would I reroute the wiring for the matrix? Will it involve pulling out all my soldered capacitors,resistors and other parts?
-
Yes I started with the PCB and am using the preprogrammed ATmega328. I'm really a newbie at all of this so I have no idea how to reroute the wiring for the matrix
-
Since the full kit was sold out I did have to order parts individually, the bits that Evil Mad Scientist doesn't sell individually had to be ordered from other sites. I got the LED matrix panel from here http://www.nooelec.com/store/components/optoe…
-
So the cable I have should work and I should check the assembly of the board again? I'm pretty sure i've soldered everything correctly in regards to capacitors and chips. If in the case I have assembled everything correctly, what is the next step to…
-
I haven't installed any of the option LEDs or the buzzer but the LED doesn't make any light and sound. I'm new at this so I wasn't sure about what you meant about the programming interface. I'm using this cable http://www.dx.com/p/6-pin-usb-to-ttl-…
-
I'm using the latest Arduino interface. I've tested the Meggy Jr's power with a multimeter and the current is going through and the reset button seems to prompt more avrdude: stk500_getsync() messages when I press it. I mentioned the chip's orientat…
