Maintenance notice: These forum archives are read-only, and will be removed shortly. Please visit our forums at their new location, https://www.evilmadscientist.com/forums/.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Register

haroldj1956

About

Username
haroldj1956
Joined
Visits
0
Last Active
Roles
Member

Comments

  • No, it is fiberglass, but it looks like it sat somewhere very dirty and got wet or soaked with something so the fiberglass was falling apart. I bought the new board, checked the motors (with a ramps board), so I know that much is ok. I think the rc …
    in NO RESPONSE FROM SERVO Comment by haroldj1956 March 2016
  • I assume it was one of the earliest models. The board was cracked along with the frame. I am now printing a frame from thingiverse to try to put these motors and the new board on because it is falling apart. I think the previous person got it from s…
    in NO RESPONSE FROM SERVO Comment by haroldj1956 March 2016
  • Yes, I found a cold solder joint and resoldered it. Now the pen is working properly, but the motors are "jerky", like very low resolution. Is there a setting for this?
    in NO RESPONSE FROM SERVO Comment by haroldj1956 March 2016
  • no, it doesn't respond at allit is plugged into B1 with the brown wire toward the edge of the board.
    in NO RESPONSE FROM SERVO Comment by haroldj1956 March 2016