Maintenance notice:
These forum archives are read-only, and will be removed shortly.
Please visit our forums at their new location, https://www.evilmadscientist.com/forums/.
Kal22378
About
- Username
- Kal22378
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
Ok, thanks Windell
-
Is it necesary to connect J1 through J4? Or can I leave those connections out?
-
Ok....Thank you Lenore.
-
For the Octolively schematic I mean. Thanks
-
Hey Windell.....I was wondering if a different Atmega microcontroller would work with this code? Atmega16? Atmega32?
-
How far apart do you recomend that the ir tx and ir rx be spaced apart?
-
Ok thanks
-
I have another question for you Windell. Can i make one atmega164 control 128 sensors and leds by using a TLC5940 and a 16 to 1 MUX sheild? If so do i need to rewrite a new code also?
-
Ok, Thanks again Windell.
-
I have one more question about these boards. If I connect multiple boards together and if I press one mode switch will it sync all of the other boards to that mode?
-
Ok thank you for explaining this to me. I am new at this, but im sure you could tell..!!!!
-
Ok, so if I write the code onto a new atmega 164 it will be programmed the same way to use the internal oscillator?
-
Ok. Do you know what the voltage would be at those pins? Would it be 5v as to what is applied to the microcontroller?, Thanks
-
Ok...thanks.
-
I have one more Question for you? can I connect one mode switch to multiple ic's or do the have to be individule?
-
Thank You Lenore for the help. Yes I did, I was making an assumption as to those pins corresponding but was not sure.Thanks again.
